diff --git a/README.md b/README.md index e01929d5..cbf1d784 100644 --- a/README.md +++ b/README.md @@ -16,9 +16,9 @@ The source is organized as follows: 2. Fetch the latest pre-built bladeRF [FPGA image]. See the README.md in the [hdl] directory for more information. 3. Fetch the latest pre-built bladeRF [firmware image]. See the README.md in the [fx3_firmware] directory for more information. 4. Follow the instructions in the [host] directory to build and install libbladeRF and the bladeRF-cli utility. -5. Attach the bladeRF board to your fastest USB port. After flashing firmware, be sure to press the reset button or unplug/replug the device. -6. If you haven't upgraded your firmware, run ```bladeRF-flash -f ```. This upgrade is required to utilize libusb support. Be sure to reset or power-cycle the board after flashing the firmware. - - If your board is stuck in the FX3 bootloader or is at factory firmware or v1.2, see [bladeRF-flash] for additional details. +5. Attach the bladeRF board to your fastest USB port. +6. If you haven't upgraded your firmware, run ```bladeRF-cli -f ```. This upgrade is required to utilize libusb support. Be sure to reset or power-cycle the board after flashing the firmware. + - If your board is stuck in the FX3 bootloader or is at factory firmware or v1.2, see the recovery command in bladeRF-cli for additional details. 7. You should now be able to see your device in the list output via ```bladeRF-cli -p``` 8. See the overview of the [bladeRF-cli] for more information about loading the FPGA and using the command line interface tool