This adds a bladerf_get_fpga_bytes() function, which returns the
expected length of the FPGA image.
This is a dynamic replacement for BLADERF_FLASH_BYTE_LEN_FPGA,
which has been removed.
In particular, this is used in spi_flash_write_fpga_bitstream() and
spi_flash_erase_fpga() to determine the number of blocks to erase
during FPGA flashing operations.
This fixes an issue where xA9 boards were not being adequately
erased before writing.
Replaced these macros with appropriate calculations using
BLADERF_FLASH_ADDR_FIRMWARE and the page size held in the device's flash
architecture structure. Page size may change depending on the flash
used.
Replaced this macro with an appropriate calculation using the
BLADERF_FLASH_ADDR_FPGA macro and the page size held in the device's
flash architecture structure. Page size may change depending on the
flash used.
The BLADERF_FLASH_NUM_EBS macro was replaced with data from the device's
flash architecture structure (e.g. dev->flash_arch->num_ebs).
Functions with new parameters include:
- spi_flash.c: check_eb_access() - bladeRF device handle
The BLADERF_FLASH_NUM_PAGES macro was replaced with data from the
device's flash architecture structure (e.g. dev->flash_arch->num_pages).
Functions with new parameters include:
- spi_flash.c: check_page_access() - bladeRF device handle
Fixes#607
The nios_gpio bit assignment for AGC_EN was already being used for
led(1). This commit also fixes a bug in the agc_band_sel signal
assignment introduced in 3b670ca.
* host: libbladeRF: deprecate bladeRF1 gain controls
We now have bladerf_{get,set}_gain and bladerf_{get,set}_gain_stage,
which are both general-purpose functions replacing the bladeRF1-specific
VGA/LNA library calls.
* host: libbladeRF: deprecate bladeRF1 trimdac controls
Instead of bladerf_dac_write and bladerf_dac_read, folks should use
bladerf_trim_dac_write and bladerf_trim_dac_read.