#include #include #include #include #define NUM_FREQUENCIES 6 #define ITERATIONS 10000 int example(struct bladerf *dev, bladerf_channel ch) { /** [example] */ int status; unsigned int i, j; // clang-format off const unsigned int frequencies[NUM_FREQUENCIES] = { 902000000, 903000000, 904000000, 925000000, 926000000, 927000000, }; // clang-format on struct bladerf_quick_tune quick_tunes[NUM_FREQUENCIES]; /* Get our quick tune parameters for each frequency we'll be using */ for (i = 0; i < NUM_FREQUENCIES; i++) { status = bladerf_set_frequency(dev, ch, frequencies[i]); if (status != 0) { fprintf(stderr, "Failed to set frequency to %u Hz: %s\n", frequencies[i], bladerf_strerror(status)); return status; } status = bladerf_get_quick_tune(dev, ch, &quick_tunes[i]); if (status != 0) { fprintf(stderr, "Failed to get quick tune for %u Hz: %s\n", frequencies[i], bladerf_strerror(status)); return status; } } for (i = j = 0; i < ITERATIONS; i++) { /* Tune to the specified frequency immediately via BLADERF_RETUNE_NOW. * * Alternatively, this re-tune could be scheduled by providing a * timestamp counter value */ status = bladerf_schedule_retune(dev, ch, BLADERF_RETUNE_NOW, 0, &quick_tunes[j]); if (status != 0) { fprintf(stderr, "Failed to apply quick tune: %s\n", bladerf_strerror(status)); return status; } j = (j + 1) % NUM_FREQUENCIES; /* ... Handle signals at current frequency ... */ } /** [example] */ return status; } int main(int argc, char *argv[]) { int status = 0; struct bladerf *dev = NULL; struct bladerf_devinfo dev_info; /* Initialize the information used to identify the desired device * to all wildcard (i.e., "any device") values */ bladerf_init_devinfo(&dev_info); /* Request a device with the provided serial number. * Invalid strings should simply fail to match a device. */ if (argc >= 2) { strncpy(dev_info.serial, argv[1], sizeof(dev_info.serial) - 1); } status = bladerf_open_with_devinfo(&dev, &dev_info); if (status != 0) { fprintf(stderr, "Unable to open device: %s\n", bladerf_strerror(status)); return 1; } /* A quick check that this works is to watch LO leakage on a VSA */ status = bladerf_enable_module(dev, BLADERF_TX, true); if (status != 0) { fprintf(stderr, "Failed to enable TX: %s\n", bladerf_strerror(status)); return status; } status = example(dev, BLADERF_CHANNEL_TX(0)); bladerf_enable_module(dev, BLADERF_TX, false); bladerf_close(dev); return status; }