bladeRF USB 3.0 Superspeed Software Defined Radio Source Code
http://nuand.com
- C 45.8%
- VHDL 21%
- Verilog 15.8%
- Tcl 3.8%
- MATLAB 3.2%
- Other 10.3%
Usage:
```
bladeRF> help backup
backup <file> [address,len]
Backup a flash data to a file.
`address' defaults to the address of the calibration data.
`len' defaults the size of the calibration data (256 bytes).
bladeRF> help restore
restore file [address,len]
Restore flash data from a file.
<address> defaults to the address of the factory calibration data or the
address stored in the metadata section of the image if it exists
<len> defaults the size of the factory calibration data (256 bytes) or
the length of the image given
```
|
||
|---|---|---|
| debian | ||
| firmware_common | ||
| fx3_firmware | ||
| hdl | ||
| host | ||
| legal | ||
| .gitignore | ||
| CMakeLists.txt | ||
| CONTRIBUTORS | ||
| COPYING | ||
| README.md | ||
bladeRF Source
This repository contains all the source code required to program and interact with a bladeRF platform, including firmware for the Cypress FX3 USB controller, HDL for the Altera Cyclone IV FPGA, and C code for the host side libraries, drivers, and utilities. The source is organized as follows:
| Directory | Description |
|---|---|
| firmware_common | Source and header files common between firmware and host software |
| fx3_firmware | Firmware for the Cypress FX3 USB controller |
| hdl | All HDL code associated with the Cyclone IV FPGA |
| host | Host-side libraries, drivers, utilities and samples |
Quick Start
- Clone this repository via:
git clone https://github.com/Nuand/bladeRF.git - Fetch the latest pre-built bladeRF FPGA image. See the README.md in the hdl directory for more information.
- Fetch the latest pre-built bladeRF firmware image. See the README.md in the fx3_firmware directory for more information.
- Follow the instructions in the host directory to build and install libbladeRF and the bladeRF-cli utility.
- Attach the bladeRF board to your fastest USB port. After flashing firmware, be sure to press the reset button or unplug/replug the device.
- If you haven't upgraded your firmware, run
bladeRF-flash -f <path_to_prebuilt_firmware>. This upgrade is required to utilize libusb support. Be sure to reset or power-cycle the board after flashing the firmware.
- If your board is stuck in the FX3 bootloader or is at factory firmware or v1.2, see bladeRF-flash for additional details.
- You should now be able to see your device in the list output via
bladeRF-cli -p - See the overview of the bladeRF-cli for more information about loading the FPGA and using the command line interface tool
For more information, see the bladeRF wiki