bladeRF/common
Robert Ghilduta 8d9ed972ca fix HS buffering
This commit defines nios_gpio(7) as the GPIF buffer size control signal. The FX3
firmware makes the DMA engine operate on GPIF buffers that are twice the size of
the maximum sized URB. Since this is speed dependent, bladeRFs operating in HS
will have their GPIF DMA controllers only read 1024 bytes of data (512*2)
instead of 2048 (1024) as is expected when the device is in SS mode. To fix
this, the driver tells the library when a device is HS, the library then s the
nios_gpio bit that causes the FPGA to limit itself to only reading/writing to
the 32bit GPIF for 256 cycle at a time (instead of 512 cycles at SS).
2013-07-22 03:45:40 -07:00
..
bladeRF.h fix HS buffering 2013-07-22 03:45:40 -07:00