bladeRF/hdl/quartus
Brian Padalino 65e764d4bb adsb: Adding FPGA based ADSB decoding.
This commit adds all the files required for using the FPGA on
the bladeRF as an ADSB message decoder.  The decoder uses a low
IF approach for decoding the PPM messages from ADSB.  The FPGA
processing expects a samplerate of 16 MHz and the IF to be at
4 MHz.  The FPGA will mix, filter and turn the result into a
power value.  This power value is then compared against a noise
floor, the preamble is searched and, if found, one of a number
of message decoders are used to decode the data.  If the CRC
does not pass, a bit flipping technique is used to flip the
lowest 5 soft decisions and re-try the CRC.  If successful,
the message is sent into a holding area and into a FIFO which
collects the ADSB messages.  After a timeout period, if messages
have not filled the FIFO, zeros are stuffed until the FIFO is
full enough for a DMA transfer to the host.

An example of a host application for receiving the ADSB messages
is located in the example directory.
2016-04-27 23:58:28 -07:00
..
signaltap hdl: Fixed tune reference MUX select inputs and 2015-12-14 15:29:59 -05:00
bladerf.tcl adsb: Adding FPGA based ADSB decoding. 2016-04-27 23:58:28 -07:00
build.tcl build: Fix SignalTap in scripted builds 2016-04-01 23:19:31 -04:00
build_bladerf.sh adsb: Adding FPGA based ADSB decoding. 2016-04-27 23:58:28 -07:00
ip.ipx fpga: Changed build system. 2013-06-16 18:15:56 -07:00