This commit adds all the files required for using the FPGA on the bladeRF as an ADSB message decoder. The decoder uses a low IF approach for decoding the PPM messages from ADSB. The FPGA processing expects a samplerate of 16 MHz and the IF to be at 4 MHz. The FPGA will mix, filter and turn the result into a power value. This power value is then compared against a noise floor, the preamble is searched and, if found, one of a number of message decoders are used to decode the data. If the CRC does not pass, a bit flipping technique is used to flip the lowest 5 soft decisions and re-try the CRC. If successful, the message is sent into a holding area and into a FIFO which collects the ADSB messages. After a timeout period, if messages have not filled the FIFO, zeros are stuffed until the FIFO is full enough for a DMA transfer to the host. An example of a host application for receiving the ADSB messages is located in the example directory. |
||
|---|---|---|
| .. | ||
| signaltap | ||
| bladerf.tcl | ||
| build.tcl | ||
| build_bladerf.sh | ||
| ip.ipx | ||