bladeRF USB 3.0 Superspeed Software Defined Radio Source Code
http://nuand.com
- C 45.8%
- VHDL 21%
- Verilog 15.8%
- Tcl 3.8%
- MATLAB 3.2%
- Other 10.3%
The rx and tx CLI commands now use the asynchronous stream interface to yield more acceptable performance, and this code has been overhauled for better readability. Command parameters have been added to allow for configuration of the stream. Although a bit overzealous, as "lock it if you use it" approach is taken here. Optimizations may follow later.. Some rx/tx parameters now support K/M/G suffixes, where relevant. To support sample rate sanity checks, an API function to check the current USB speed has been added to libbladeRF. This speed is now reported in the CLI 'info' command. |
||
|---|---|---|
| firmware_common | ||
| fx3_firmware | ||
| hdl | ||
| host | ||
| .gitignore | ||
| CMakeLists.txt | ||
| CONTRIBUTORS | ||
| COPYING | ||
| README.md | ||
bladeRF Source
This repository contains all the source code required to program and interact with a bladeRF platform, including firmware for the Cypress FX3 USB controller, HDL for the Altera Cyclone IV FPGA, and C code for the host side libraries, drivers, and utilities. The source is organized as follows:
| Directory | Description |
|---|---|
| firmware_common | Source and header files common between firmware and host software |
| fx3_firmware | Firmware for the Cypress FX3 USB controller |
| hdl | All HDL code associated with the Cyclone IV FPGA |
| host | Host-side libraries, drivers, utilities and samples |
Quick Start
- Clone this repository via:
git clone https://github.com/Nuand/bladeRF.git - Fetch the latest pre-built bladeRF FPGA image. See the README.md in the hdl directory for more information.
- Fetch the latest pre-built bladeRF firmware image. See the README.md in the fx3_firmware directory for more information.
- Follow the instructions in the host directory to build and install libbladeRF and the bladeRF-cli utility.
- Attach the bladeRF board to your fastest USB port. After flashing firmware, be sure to press the reset button or unplug/replug the device.
- If you haven't upgraded your firmware, run
bladeRF-flash -f <path_to_prebuilt_firmware>. This upgrade is required to utilize libusb support. Be sure to reset or power-cycle the board after flashing the firmware.
- If your board is stuck in the FX3 bootloader or is at factory firmware or v1.2, see bladeRF-flash for additional details.
- You should now be able to see your device in the list output via
bladeRF-cli -p - See the overview of the bladeRF-cli for more information about loading the FPGA and using the command line interface tool
Coming Soon: Quick Start information for GNU Radio support via gr-osmosdr
In the meantime, see the Building GNURADIO from GIT section of kb3gtn's bladeRF setup guide for information on this.