- Removed incorrect block size, and noted this for both Hi-Speed
and SuperSpeed configurations.
- Attempted to make this description clearer by keeping things
in units of samples, where possible.
- Explicitly noted that callers of the sync interface do not need
to be concerned with underlying metadata position and layout --
only async interface users do.
- Added link to libbladeRF's `metadata.h` for reference.
This function was incorrectly located in the "Low-Level" group.
There has been some confusion reported about how to properly use this
function. As such, the description has been updated to better describe
when to use this function versus the timestamp metadata mechanisms.
This commit introduces high-level triggering API functions. This allows
multiple devices to be configured to synchornously start RX/TX
operations based upon the assertion of an external I/O signal.
This higher level API is intended to decouple usage from the underlying
register interface and provide some provisions for future
development of other trigger signals (both as official and user
customizations HW/SW customizations).
The general usage of this API is as follows:
1. Create a bladerf_trigger structure for each trigger in the entire
system. bladerf_trigger_init() may be used to initialize this
structure.
2. Arm 1 trigger master device via bladerf_trigger_arm().
3. Arm trigger slaves via bladerf_trigger_arm().
4. Configure and start sample streams. No samples will be
transmitted or received until the trigger fires. Ensure
the timeouts used are sufficiently large.
5. Fire the trigger on the master device via bladerf_trigger_fire().
6. Transmit and receive samples.
7. Re-arm triggers via bladerf_trigger_arm() and repeat 5-6 as
needed.
8. Disable triggering by setting each trigger's role to
BLADERF_TRIGGER_ROLE_DISABLED and then calling
bladerf_trigger_arm(dev, false);
The XB-300 is an amplifier board that features a Low Noise Amplifier, a
Power Amplifier, a TX power monitor, and a 2:1 combiner for RX reception
along a TRX path. The TRX path has to be configured to TX for the PA to
output.